The best way to Install a Ceiling Fan in a Vaulted Ceiling Without Attic Access

Vaulted ceilings lend an amount of beauty to your room; the ceiling produces the illusion of an area that is bigger. Many citizens want to install a ceiling fan in a ceiling to keep the area air but models that are vaulted don’t permit attic entry. Residents can include the lover that is required by utilizing a fixture that is previously installed relationship as well as a lengthy down-rod to clear the angled sides of the ceiling.

Turn the circuit-breaker that gives energy to be eliminated in the main panel off. Use a circuit tester system that is non-contact to confirm that energy continues to be effectively switched off off.

Access the fixture using a ladder. Ask a buddy to support the the legs while operating to ensure the security of the ladder.

Remove. Pull the fixture in the ceiling. Untwist the wires from the fixture to the electrical wiring of the home’s. Place the fixture apart. Allow the electrical wiring of the ceiling to to hold down briefly.

Look up to the outdated hole in the ceiling of the fixture and find the box. Unscrew the box from its place using a screwdriver. Place the box apart.

Locate a ceiling joist in the outdated hole of the fixture. The joist could be adjacent to the outdated hole of the fixture.

Place a power pancake box from the ceiling to ensure it’s beneath the the ceiling joist that is formerly positioned. Draw a circle round the box on the ceiling using a pencil. Place the box to the aspect.

Cut out the hole that was drawn using a drywall saw. Wear eye protection since dirt will happen throughout the sawing method.

Snake the hanging wires to the knock-out hole of the pancake box. Push up the box and screw it to the ceiling joist using the provided screws as well as a power screwdriver of the box. Ensure the wires aren’t pinched throughout the attachment process.

Urethane -centered adhesive onto the trunk of the medallion piece of the fan’s. By snaking the hanging wires to the open center of the medallion place the lover medallion on the box. Push the medallion contrary to the ceiling. Secure the medallion using a screwdriver as well as the screws.

Place the metal ceiling plate from the box of the fan’s and secure with a screw-driver and screws. Ensure that the electrical wires of the ceiling protrude through the open-hole of the plate.

Hold the enthusiast assembly that is full below the midst of the medallion until its blades are obvious of the ceiling sides. Mark the wanted peak on the ceiling using a pencil.

Measure the the the exact distance involving the height that is marked along with the box having a measuring tape. Don’t calculate contrary to the ceiling; measure in the box to the level that is marked to seek out the down-rod duration required to clear the sides of the ceiling.

Place a down-rod of the length that is measured onto the lover assembly that is full. Snake the electrical wiring of the fan’s up the down-rod as it’s pressed to the enthusiast assembly. Secure the down-rod with a screwdriver along with screws.

Hold the down and lover -rod blend up to the box. Hand-twist the wires protruding from your ceiling as well as the down-rod. Consult the enthusiast person guide for the wiring configuration that is particular. Each maker h AS various wire orientations.

Secure the fan-to the box utilizing a screwdriver as well as screws. Turn the circuit-breaker straight back on in the primary panel. Turn the enthusiast on and confirm its performance.

See related