The Way to Install a Dishwasher Trim Kit

Dishwasher door trim kits hide the dishwasher allow you to customize the appearance of your kitchen or coordinate with your appliances. Kit options include either fiberglass entrance panel or a steel cover, spring assemblies that are heavy handed or access panels to accommodate to the weight added to the doorway. The real tool knowledge you need to install the kit is to use a screwdriver. This setup will be completed by an average homeowner in about an hour.

Shut off the water supply. Close to the door and engage the door lock.

Remove the screws. Remove and set them apart. Loosen the screws between the entrance panel and the doorway. These screws do not come all of the wayout, out so do not attempt and eliminate them. Remove the toe kick as well as the access panel.

Grab one of the door springs, situated near the back of the dishwasher’s end, and push toward the rear of the machine. Dislodge the hook by pulling toward the inside of the machine. Unhook the spring’s front end in the door and eliminate it. Repeat this process the door spring to eliminate.

Connect the spring to the door frame with the hook itself facing toward the exterior of the machine’s conclusion. Stretch the spring to the hole in the pair of four holes in the back of the machine as indicated by the kit instructions. Open the door. The doorway will not fall too heavily When the springs are installed with the tension that is correct. Once opened, it will not close by itself. Into the fourth or third hole, relocate the end of the spring to increase tension.

Peel off the tape covering the adhesive strips on the rear of the new door panel cover. Hold the cover in a 45-degree angle and slide it up to and underneath the escutcheon. Snap the panel and install the screws included with the kit to the base of the cover.

Tear the protective plastic coating off in the new door panel cover and discard.

Place the toe reunite in the base of the machine. Place the new entrance panel. Tighten the two screws between the entrance panel and the doorway. Install retainers at the peak of the access panel.

Reinsert the screws. Adjust the toe kick to lessen the gap in the ground level and tighten screws.

See related