Ping-pong tables aren’t complex. They include dense particleboard, satin paint with white lines, a net and thighs. When used by enthusiastic players that gouge, scratch and otherwise manhandle the desk, it gets worn or damaged over time. Repairing the table is basic, allowing you to turn to normal products and do-it-yourself practices.
Like Putty in Your Hands
Remove in the table. Inspect the table for deep scratches, gouges and cracks in the paint. Use wood putty to fill the cracks. Force the putty deep into flaws to make a smear of putty within the area using a putty knife. If the cracks in the paint are only hairline marks, do not be concerned about these; paint will burst to fill those. Check the putty after it’s dry. If you can observe a recess or dip larger gouges, apply another application of putty to measure the surface. Do not use caulk or anything with a rubbery feel to fill flaws. Look for putty that is made from timber and dries. Allow the putty to dry. Many putty dries within one hour, but based on humidity or depth, it might take longer. It ought to have a chalky, nearly brittle consistency when dry.
Sand and eloquent
Sand the tabletop by hand using 180-grit sandpaper. Begin by attaching the paper into a sanding block and removing the excess putty. Until it’s even with the surface sand it. Sand the remainder of the table using the hand block. If the block begins to slide and neglects to render a powdery substance, change the paper. When you have sanded over the entire top, resand it by hand using a folded piece of 220-grit paper. The finer grit paper helps to smooth and prep the top for paint. When the table is coated in a fine powder it’s finished. Wipe the powder off using a soft fabric. Do not use excessive force when sanding or lean on the desk too hard. Tables like this are not powerful enough with their spindly legs.
Rattle Cans
Aerosol cans are good for repainting the table. Blackboard or Utilize satin paint in any color you would like. Apply a thin, even coating of paint, working in sections, forth and back, until the tabletop is wet. Allow the paint to dry and add two coats. If it looks good you are prepared to add the lines. If you can see thin spots, it’s nice to add one or two coats. Allow the paint to dry.
Tape It
Use painter’s tape to hide the lines around the perimeter and across the sides. Press the tape down tough along the edges to prevent seepage of the paint below the tape. When you have established the lines, mask the interior of the table with paper, using the tape to hold it in place. Spray the lines using paint. One initial coat is most likely sufficient, but use two coats if lines appear thin. Peel off the paint if it’s dry. Allow the table before using it to cure overnight.